ULTRASONIC HIGH POWER PULSER
UPU3000 

System for delamination detection in wooden chip plates

This device was designed for our German customer, Fagus-GreCon and is used as a part of an online ultrasound measuring system to detect weak points, unbonded areas and air voids within particle board, MDF, OSB and LVL.

To check wood-based panels for unbonded areas and air voids, an ultrasound signal is sent through the panel. In the case of a high-quality panel, the receiver will register about 10 % of the original signal.Unbonded areas or air voids within the panel deaden the ultrasound signal so that only about 1 % of the original signal is received.

The device can generate bursts with 50 or 30kHz frequency, 1kW power and 1000V amplitude. It is also able to measure all signal parameters and transmit this data to the control unit.